Most farmers have a love-hate relationship when it comes to drying off cows.

They hate the thought of doing it, but love not having to milk those cows again until next spring.

For many, it’s a difficult job, but it's so important that it’s done right. The risk of causing problems rather than solving problems is high, particularly if using selective dry cow therapy.

Know your limits

Drying off too many cows at once will add to frustration and could tempt some people into taking shortcuts with protocol, technique and procedure.

How many one person can handle in one sitting will vary, but generally speaking the maximum is 15 to 20 before fatigue sets in.

That means the most two people can dry off is 40 cows and that’s effectively a job that should take most of the morning. However, if using selective dry cow therapy, spend twice as long at the cleaning and do half as many cows.

See the light

A head torch is very useful at drying off to give extra visibility of the teats. Surgeons wear head torches when performing an operation and farmers need to treat drying off like a surgical procedure.

Use cotton wool

Cotton wool steeped in methylated spirits is very effective at cleaning and disinfecting teat ends. Other products are good at disinfecting, but not very effective at cleaning.

Rolls of cotton wool can be purchased at farm stores or equine stores and methylated spirits can be purchased at DIY, hardware stores and at the vets.

Tear off balls of cotton wool and put them into a freezer bag and then add methylated spirits to the bag. The wipes that come with teat sealers and antibiotic tubes aren’t good enough at cleaning.

Don’t use cold tubes

It’s difficult to squeeze the dry cow antibiotic and teat sealer tubes if they are cold (below room temperature).

Some farmers will warm them up to room temperature to make them easier to squeeze. They do this by leaving them in a warm room overnight.

Do not place tubes directly in a bucket of warm water, as the water could ingress to the product.

Other farmers heat the tubes by placing a bucket of tubes into a bucket of warm water.

A potential issue with this is that the tubes are not heating at the same temperature, as those at the bottom of the bucket are going to get warmer than those at the top, which might affect the efficacy of the sealer.

Finally, when done make sure that the cows are marked as treated so if they end up mixing with the milkers it will be easy to identify them.

Hold the cows in a yard for a few hours after drying off before letting them back to clean and disinfected cubicles to allow the teat ends to close after being tubed.